Step By Step Guide To Foundation Form Installation And Choosing The Right Solutions For The Needs Of Residential Projects

Posted on: 26 May 2020

When you are building a home, the first step in the process is preparing the land and setting up the foundation forms. With residential construction, there may be some unique needs for your project, such as insulated forms, footings, and drainage systems for the foundation. In addition, some areas may need a finished solution with stamped forms for areas of the foundation that are exposed above the soil. The following step-by-step guide will help you with the process of installation and choosing the right foundation form solutions for the needs of your project:

Step 1. Establishing The Footing Needs And Structural Foundation Footing Beams

The structural loads of the building are carried down to the foundation footing beams. Therefore, the project needs to start with excavations and pouring the footing beams that support structural loads of the house above. Some of these footings may extend above the soil level and need forms to also be installed. In addition, this is when you will want to address issues like soft soils and poor compaction, which can be done with solutions like piers and soil grouting that support the structural footing beams of the foundation.

Step 2. Installing A Modern Drainage System To Keep The Home Dry

The foundation is going to need to have a modern drainage system that helps keep the foundation dry. This is something that needs to be done when the footings are poured. The drainage system should include drain tiles and aggregate to allow water and moisture to drain away from the structure freely. You can also install a permanent or temporary dry well that will give the water somewhere to go to prevent problems when setting up the forms for your foundation walls and with water damage after the project has been completed.

Step 3. Installing Aggregate And The Mechanical Conduits And Pipes

Once the drainage system has been established, it will be time to install the mechanical installations that need to be installed before the foundation walls are poured. These installations include:

  • Conduits for electrical wiring and cabling
  • Plumbing pipes
  • Water lines
  • HVAC and heating or cooling systems

These are some of the mechanical systems that may need to be installed in the foundation before the walls and concrete slabs are poured.

Step 4. Foundation Form Installation Solutions

The foundation forms will need to be installed before pouring the foundation walls and other installations. Some of the different options for the foundation form systems you use for walls include:

  • Insulated forms that are permanent
  • Modular structural forms for walls
  • Stamped brick forms for walls above the soil grade
  • Conventional foundation forms that are removed after pouring

These are some of the different foundation forms solutions that you can use for your project.

Step 5. Pouring The Foundation And Removing The Forms 

Once the forms have been poured with concrete, they can be removed after the concrete has had time to cure. You will want to remove the forms and look for imperfections and problems that need to be addressed before waterproofing. Once the foundation is ready, the drainage system can be completed, and waterproofing systems can be installed on the foundation walls where waterproofing is needed.

These are some of the things that you want to know about preparing your foundation forms for residential projects. If you are ready to start breaking ground and beginning construction of your next project, contact a foundation form service to start setting up to pour the foundation and get the project on its way to completion.

Share